ABSTRACT:
Osteoporotic vertebral fractures are a common type of fracture and affect a significant
number of subjects with osteoporosis. Despite the high fracture risk, the concomitant
occurrence of vertebral fractures at non-contiguous levels is very rare. We report
the case of a patient with three burst dorsolumbar spine fractures at non-contiguous
levels who was treated with percutaneous kyphoplasty and transpedicular posterior
fixation. Six months after the surgery, the patient walks autonomously and without
pain; in addition, there is no radiological evidence of fracture reduction loss.
Keywords: osteoporosis; fractures, bone; kyphoplasty; fracture fixation, internal.
RESUMO:
As fraturas vertebrais osteoporóticas são um tipo comum de fratura e afetam um número
significativo da população com osteoporose. Apesar do elevado risco de fratura, a
ocorrência concomitante de fraturas vertebrais em níveis não contíguos é muito rara.
Reportamos o caso de uma paciente com três fraturas explosivas da coluna dorsolombar
em níveis não contíguos, tratada com cifoplastia e fixação posterior transpedicular
por via percutânea. Seis meses após a cirurgia, a paciente tem marcha autônoma, sem
dor, e, radiologicamente, não existem evidências de perda de redução das fraturas.
Palavras-chave: osteoporose; fraturas ósseas; cifoplastia; fixação de interna de fraturas.
FIGURES
| Citation: Marques RR, Moura DL, Lourenço P. Surgical Treatment of Multiple Osteoporotic Fractures of the Dorsolumbar Spine: Case Report*. 56(2):258. doi:10.1055/s-0040-1721844 |
| Note: Study developed at the Orthopedics and Traumatology Department, Centro Hospitalar e Universitário de Coimbra, Portugal. |
| Conflict of Interests The authors have no conflict of interests to declare. |
| Received: May 25 2020; Accepted: September 17 2020 |
INTRODUCTION
Compression vertebral fractures classified as AO Spine type A are among the most relevant clinical consequences from osteoporosis, and their incidence in the older population is increasing.1 They are potential causes for chronic pain, leading to functional limitation and having a significant impact on physical activities, quality of life, and mortality. Fractures can be spontaneous or due to a traumatic event, usually resulting from a compressive mechanism involving the vertebral body. These fractures often involve the middle third of the thoracic spine and the dorsolumbar region.
Although most of these injuries are stable and feasible to conservative treatment based on rest, pain control and immobilizing orthoses, a considerable number of fractures, particularly in the dorsolumbar transition, can result in progressive height loss and increase kyphosis deformity; others may cause posterior wall rupture, leading to neural compression and neurological deficit. As such, early surgical stabilization is warranted. However, published studies show high rates of complications in osteoporotic patients undergoing surgical procedures such as kyphoplasty and posterior instrumentation, with selected series reporting adjacent vertebral fractures and material failure in about one third of these patients.2
CASE DESCRIPTION
We report the case of a very active 70-year-old woman with osteoporosis who suffered a fall from her own height at home following a syncope. She immediately presented pain at the dorsolumbar transition. After 3 days of intense, persistent pain, despite anti-inflammatory and analgesic medication, she went to the hospital. She had pain on palpation of the spinous apophysis of the dorsolumbar transition, no muscle strength deficit in the lower limbs and normal osteotendinous reflexes. Fractures of the D9, D12, and L2 vertebral bodies, classified as type A4 according to the AO Spine system, were diagnosed in an osteoporotic context (►Figure 1) in a subject with no associated conditions or chronically treated with osteoporosis-predisposing medications. The fractures showed signs of significant crushing of the intrabody bone trabeculae.
The patient underwent surgical treatment 4 days after hospital admission (►Figure 2). Kyphoplasty was performed at the D9, D12, and L2 levels using intrabody stents through a transpedicular percutaneous approach with high viscosity polymethylmethacrylate (PMMA) filling. Since the D9 vertebral body could not bear two stents, even in their smallest size (small), this level received a single stent and cement filling. A percutaneous transpedicular posterior D7-D8-D10-D11-L1-L3 vertebrae fixation was performed using bars molded according to the patient's anatomy in thoracic kyphosis and lumbar lordosis (VIPER system, DePuy/Synthes, Warsaw, IN, USA) (►Figure 3).
The patient could stand up on the first postoperative day and then walked with a dorsolumbar support. Six weeks after the surgery, she could walk alone presenting only residual pain. Anti-osteoporotic treatment started with denosumab, and, 6 months after surgery, the patient walks alone, with no pain complaints or loss of fracture reduction, and with favorable healing (►Figure 4).
DISCUSSÃO
A paciente discutida no presente artigo apresenta um raro caso de fraturas osteoporóticas de vários níveis não contíguos da coluna dorsolombar, tratado de forma percutânea, em que se garantiu não só suporte anterior pelas cifoplastias, mas também suporte da banda de tensão posterior através da fixação posterior. A opção, nesta paciente, é justificada pelo elevado risco de desenvolver cifose progressiva. Não obstante, a instrumentação tem uma extensão considerável, e a extração poderá ser ponderada após a consolidação das fraturas.
Um dos principais riscos das fraturas osteoporóticas vertebrais é a ocorrência progressiva do colapso do corpo vertebral, assim como o desenvolvimento gradual de deformidades em cifose.3 De fato, esta perturbação do equilíbrio sagital adquire maior relevo nos doentes idosos com osteoporose, uma vez que a probabilidade de agravamento progressivo das alterações sagitais da coluna é maior. Consequentemente, a tensão dos músculos paravertebrais aumenta, provocando dor crônica, e o desequilíbrio sagital pode inclusivamente causar novas fraturas. Além disso, um número de fraturas vertebrais mais elevado deslocará mais ainda o centro de gravidade da coluna anteriormente.
A cifoplastia com PMMA é uma abordagem bem documentada na correção e na prevenção do colapso e deformidades, importante no restauro da harmonia e equilíbrio sagital global da coluna.4 No entanto, a correção obtida isoladamente por este tipo de procedimento pode, em 10 a 30% dos casos, falir gradualmente e causar aumento da cifose.5 Por outro lado, até 25% dos casos desenvolve fraturas em nível adjacente, frequentemente a vértebra osteoporótica superior.3
No caso apresentado, a presença de 3 fraturas explosivas concomitantes em D9, D12 e L2, com elevado risco de colapso pós-traumático, aumenta consideravelmente o risco de complicações da fixação posterior isolada. A força de cada ponto de fixação da instrumentação posterior é menor na coluna osteoporótica, uma vez que a força de pullout, o torque de cutout e o torque máximo de inserção são diretamente proporcionais à densidade mineral óssea.6 A presença de osteoporose em pacientes submetidos a tratamento cirúrgico da coluna tem sido associada com fraturas vertebrais após instrumentação, pseudartroses e à falência secundária de material.7 Estudos biomecânicos têm demonstrado que o suporte insuficiente da coluna anterior pode ser responsável por estes resultados insatisfatórios, além da fixação precária que o osso de baixa densidade mineral oferece.8 Além do mais, a cavidade formada no corpo vertebral fraturado após a distração atrasa a consolidação e favorece a perda de redução.9 Optou-se, assim, por combinar a cifoplastia com stent e a fixação posterior percutânea. Decidiu-se aplicar stents na medida em que estes implantes além de oferecerem uma maior rigidez do corpo vertebral, permitem diminuir o risco de extravasamento de cimento porque criam uma cavidade intrassomática rodeada pelo implante. Nas fraturas em compressão, esta técnica híbrida foi associada com menos dor no período pós-operatório imediato e possibilitou a manutenção da altura do corpo vertebral fraturado praticamente total, com um baixo risco de recorrência da cifose.10 Desta forma, acreditamos mitigar o risco de colapso anterior por ausência de suporte na coluna anterior na fixação posterior, assim como o risco de falência do material de fixação e das fraturas osteoporóticas adjacentes.
DISCUSSION
The patient described in the present article presents a rare case of osteoporotic fractures of several non-contiguous levels of the dorsolumbar spine submitted to percutaneous treatment, assuring not only anterior support by kyphoplasty but also posterior tension band support through posterior fixation. This choice is justified by the high risk of progressive kyphosis development. Nevertheless, the instrumentation is considerably extent, and extraction may be considered after fractures consolidation.
The main risks in osteoporotic vertebral fractures include the progressive collapse of the vertebral body up to vertebra plana formation and gradual development of kyphotic deformities.3 In fact, this sagittal balance disturbance is critical in elderly patients with osteoporosis due to the higher probability of progressive worsening of spinal sagittal changes. As a result, the paravertebral muscle tension increases, thus causing chronic pain, and sagittal imbalance may even lead to new fractures. In addition, a higher number of vertebral fractures will further anteriorly displace the spine's center of gravity.
Kyphoplasty with polymethylmetacrylate (PMMA) application is a well-documented procedure to correct and prevent collapse and deformities, with an important role in restoring harmony and overall sagittal balance of the spine.4 However, in 10 to 30% of cases, the correction obtained by this type of procedure alone can gradually fail and increase kyphosis.5 On the other hand, up to 25% of these cases develop fractures at an adjacent level, often the upper osteoporotic vertebra.3
In our case, the presence of three concomitant burst fractures in D9, D12, and L2, with a high risk of posttraumatic collapse, increased considerably the risk of complications of the posterior fixation alone. The strength of each posterior instrumentation fixation point is lower at the osteoporotic spine since the pullout force, the cut-out torque and the maximum insertion torque are directly proportional to the bone mineral density.6 In patients undergoing spinal surgical treatment, osteoporosis has been associated with postinstrumentation vertebral fractures, pseudarthrosis, and secondary material failure.7 Biomechanical studies have shown that insufficient anterior column support, along with the poor fixation provided by bones with low mineral density, may account for these unsuccessful outcomes.8 Furthermore, the cavity formed at the fractured vertebral body after distraction delays consolidation and favors reduction loss.9 Thus, we decided to combine a kyphoplasty with stent and percutaneous posterior fixation. Stents were selected because they provide greater vertebral body rigidity and reduce the risk of cement overflow, since they create an intrabody cavity surrounded by the implant. In compressive fractures, this hybrid technique was associated with less pain during the immediate postoperative period and spared virtually the whole height of the fractured vertebral body, with a low risk of recurrent kyphosis.10 Therefore, we believe that it mitigates the risk of anterior collapse due to the lack of anterior column support at the posterior fixation, as well as the risk of fixation material failure and adjacent osteoporotic fractures.
